Switching of medium voltage capacitor banks and filter circuits poses special demands on the circuit-breaker. Potentially critical impacts are the inrush current and the stress of the recovery voltage. This technical article deals with the requirements of capacitor banks without reactors, capacitor banks with inrush limiting. The permissible inrush current depends on the ratings of both the circuit-breaker and the capacitor bank. There are two possible ways to reduce a high inrush making currentand to move it into the permissible region: 1. The limitation of the inrush current to ≤ 10 kA (or ≤ 5 kA) by means of a. Immediately after switching off the voltage UF is present on the load side of the breaker, which can be determined as described below. Figure 4–. When filter circuits or reactor-capacitor units are switched off the recovery voltage across the breaker is higher than when other loads are switched. The reasons for this are on the one hand.